Electric generators and motors

Other important energy-conversion devices emerged during the 19th century. During the early 1830s the English physicist and chemist Michael Faraday discovered a means by which to convert mechanical energy into electricity on a large scale. While engaged in experimental work on magnetism, Faraday found that moving a permanent magnet into and out of a coil of wire induced an electric current in the wire. This process, called electromagnetic induction, provided the working principle for electric generators.

During the late 1860s Zénobe-Théophile Gramme, a French engineer and inventor, built a continuous-current generator. Dubbed the Gramme dynamo, this device contributed much to the general acceptance of electric power. By the early 1870s Gramme had developed several other dynamos, one of which was reversible and could be used as an electric motor. Electric motors, which convert electrical energy to mechanical energy, run virtually every kind of machine that uses electricity.

All of Gramme's machines were direct-current (DC) devices. It was not until 1888 that Nikola Tesla, a Serbian-American inventor, introduced the prototype of the present-day alternating-current (AC) motor.

Direct energy-conversion devices

Most of these energy converters, sometimes called static energy-conversion devices, use electrons as their “working fluid” in place of the vapour or gas employed by such dynamic heat engines as the external-combustion and internal-combustion engines mentioned above. In recent years, direct energy-conversion devices have received much attention because of the necessity to develop more efficient ways of transforming available forms of primary energy into electric power. Four such devices—the electric battery, the fuel cell, the thermoelectric generator (or at least its working principle), and the solar cell—had their origins in the early 1800s.

The battery, invented by the Italian physicist Alessandro Volta about 1800, changes chemical energy directly into an electric current. A device of this type has two electrodes, each of which is made of a different chemical. As chemical reactions occur, electrons are released on the negative electrode and made to flow through an external circuit to thepositive electrode. The process continues until the circuit is interrupted or one of the reactants is exhausted. The forerunners of the modern dry cell and the lead-acid storage battery appeared during the second half of the 19th century.

The fuel cell, another electrochemical producer of electricity, was developed by William Robert Grove, a British physicist, in 1839. In a fuel cell, continuous operation is achieved by feeding fuel (e.g., hydrogen) and an oxidizer (oxygen) to the cell and removing the reaction products.

Thermoelectric generators are devices that convert heat directly into electricity. Electric current is generated when electrons are driven by thermal energy across a potential difference at the junction of two conductors made of dissimilar materials. This effect was discovered by Thomas Johann Seebeck, a German physicist, in 1821. Seebeck observed that a compass needle near a circuit made of different conducting materials was deflected when one of the junctions was heated. He investigated various materials that produce electric energy with an efficiency of3 percent. This efficiency was comparable to that of the steam engines of the day. Yet, the significance of the discovery of the thermoelectric effect went unrecognized as a means of producing electricity because of Seebeck's misinterpretation of the phenomenon as a magnetic effect caused by a difference in temperature. A basic theory of thermoelectricity was finally formulated during the early 1900s, though no functional generators were developed until much later.

In a solar cell, radiant energy drives electrons across a potential difference at a semiconductor junction in which the concentrations of impurities are different on the two sides of the junction. What is often considered the first genuine solar cell was built in the late 1800s by Charles Fritts, who used junctions formed by coating selenium (a semiconductor) with an extremely thin layer of gold (see Exploiting renewable energy sources below).

Text B

Поиск по сайту: